How to achieve high quality cutting with fiber laser cutting machine
The cutting quality of fiber optic laser cutting machine is the concern of the customer, and it is also a skill training that the technicians need to keep improving. But if you want to cut satisfactory samples, you need to use fiber optic laser cutting machine scientifically.
The most important index of high-quality laser cutting is that there is no cutting defect and the roughness value of cutting surface is small, so the target of real-time detection should be able to identify cutting defect and detect the information reflecting the roughness of cutting surface, among which the roughness information is the most important and difficult to obtain.
Therefore, it is difficult to obtain valuable roughness information of the cutting machine surface, especially the roughness information of the near lower edge, due to the limitation of the optical radiation intensity signal of the laser cutting edge. By using the visual megaphonia to monitor the images of both the cut edge and the fireflower shower, more comprehensive and abundant information about the cutting defects and the roughness of the cutting surface can be obtained.
In addition, the fireshower ejected from the lower end of the cutting seam is closely related to the quality of the lower edge of the cutting surface, which is an important information source for obtaining the roughness of the lower edge of the cutting surface.
From the following three points, we will look at the evaluation criteria of cutting quality and the methods to achieve high-quality cutting:
1, the cutting section is smooth, less grain, no brittle fracture. Fiber optic laser cutting machine in the cutting, cutting marks will be shown after the laser beam deviation, so at the end of the cutting process to slow down a little, can eliminate the formation of grain.
2. Size of slit width. This factor is related to the thickness of the cutting plate and the size of the nozzle, in general, the cutting plate slit is narrow, the selected nozzle is small, because the need for less air injection, similarly, thick plate requires more air injection, so the nozzle is also large, the cutting seam will be correspondingly wider. So to find the right type of nozzle, in order to cut a good product.
3. Good verticality of cutting and small heat affected area. The perpendicularity of the cutting edge is important. When it is away from the focus, the laser beam diverges. Depending on where the focus is, the cut widens toward the top or bottom.
Although the operation of laser cutting equipment is relatively simple, but in the process of cutting still need to be taken seriously, the correct choice of focus position, scientific and correct use of laser cutting machine, in order to cut a high-quality workpiece, the machine, the operator is also a safety guarantee.









