Laser Cladding And Repair Process For Shaft Parts

Sep 06, 2019

Leave a message

(1) Pretreatment process: including degreasing, derusting → blast cleaning (further cleaning) → pre-crushing treatment (cleaning the area where laser cladding is required, and leveling the area with obvious defects);


(2) Quality inspection process: The surface of the cleaned surface is inspected by magnetic particle inspection, X-ray inspection, fluorescent detection or display agent detection to determine whether there are obvious defects.


(3) Laser cladding: laser cladding with alloy powder with independent intellectual property rights, no preheating, no metallurgical cracking, high hardness can reach HRC63.


(4) Subsequent processing: including polishing and finishing of the laser cladding area; if necessary, spraying the wear-resistant coating.


(5) Quality inspection and acceptance: The inspection method is the same as step 2. It is confirmed that there are no defects on the surface of the parts after laser cladding treatment, and the acceptance can be carried out. After the above processing steps, the shaft parts can be renewed as new.